Dear Jim: My single-pane windows are still good, but much heat comes in during summer and its chilly near them during winter. Would installing one of the newer year-round or heat-control window films help much? – Bob T.
Dear Bob: Installing window film can be an effective method to improve the efficiency of your window glass. The newer window films are neither highly reflective nor darkly tinted, so your house will not look like an office building with mirrors for windows. Some of the films are barely perceptible.
The newer energy-control window films use a technology similar to super-efficient glass in new replacement windows. A low-emissivity coating, which is a several-atom thickness of metal, is applied to the film. Visible easily light passes through the coating, but it blocks heat energy.
The amount of tint applied to the window film also affects the amount of the suns heat which passes through the glass. With the low-emissivity coating on a dark film, a high percentage of heat and glare is blocked. This type of sun-control film is typically used in hot climates.
For homeowners who wish to save energy year-round, a lightly tinted window film is best. This type of film barely alters the view outdoors, but it blocks some summer heat in addition to heat loss during winter. Also, during winter, it still allows some free passive solar heat in through the window and it reduces that chilly feeling when you are near a window.
A secondary benefit of installing window film is it blocks the majority of the suns UV rays that fade curtains, furniture and carpeting.
Many homeowners install the nearly clear window film solely for this purpose.
If you have double-pane windows, check with your window manufacturer before installing window film. Dark films can warm the glass which may affect the airtight seal between the panes. The nearly clear films do not cause much heat buildup, but still check to make sure about the glass warranty.
Installing the film yourself is not difficult. There is a water-activated adhesive on the window film.
Make sure the glass is clean and the film is thoroughly wet.
Apply the film and carefully run the squeegee over it to force out all the bubbles to the edges.
Dear Jim: When I build an addition on to my home, I plan to use rigid foam insulated sheathing on the outside of the wall studs. Will it harm the efficiency to use more nails and fasteners for a stronger wall? – Chris F.
Dear Chris: Adding more nails and metal fasteners than recommended by the manufacturer does not produce a better wall.
It is usually best to follow the foam manufacturers instructions or building code requirements. Any metal fasteners decrease the effectiveness of rigid foam insulation.
Using just the recommended number of nails and fasteners can reduce the overall insulation value by 5 percent or more.